Food & Dry Goods Box

Reading the code A01.70.00.00

A01.70.00.00 sits in ECMA group A: long-seam-glued folding cartons with rectangular surfaces. The carton is glued into a sleeve along its long seam, and the code's panels are numbered 1 to 4 starting from that glue seam. The two leading blocks describe the closure systems — the bottom first (01), then the top (70); the following blocks record which panel each closure's flap is connected to.

Here the bottom end has no closing flaps (01), and the top closure is recorded as 70.

How the closures behave

This end of the carton stays open — there are no closing flaps, so the structure works as an open end for sleeves, display cartons or designs closed by other means.

Typical uses

Open-ended constructions serve as sleeves and display-oriented cartons, or as bodies completed by another component of the pack.

Dimensions and board

The parameters above — length, width, depth and paper thickness — drive the whole blank. Board caliper is not a footnote: tuck clearances, lock engagement and panel fit all scale with it, which is why it is a first-class input to the parametric model rather than an allowance you add by hand.

Every value is validated against the template's supported range, and the 2D dieline and 3D fold preview regenerate together from the same structure. Confirm final board grade, grain direction and tolerances with your converter before production.

What is Food & Dry Goods Box — Sealed Gable Top, Open Base?

ECMA A01.70.00.00 is a long-seam-glued folding carton in ECMA group A (base: no closing flaps; top: closure system 70).

Which dimensions does the Food & Dry Goods Box — Sealed Gable Top, Open Base dieline need?

5 parameters drive the blank: L (length), W (width), D (depth), H (height), Paper thickness (mm, um). Each value is validated against the template's supported range, and the whole dieline regenerates from them.

Can I see how Food & Dry Goods Box — Sealed Gable Top, Open Base folds before cutting it?

Yes. The interactive 3D fold preview and the 2D dieline are generated from the same parametric structure, so the fold you watch on screen is the geometry of the sheet you cut. Open the template in the preview studio to fold it at your own dimensions.