Collapsible Tray with Hinged Lid — Model 2

Reading the code FEFCO 0761

The 07 series holds the ready-glued, self-erecting constructions: boxes glued during manufacture that are delivered flat or collapsed and spring into shape in one movement at the point of packing.

Within the series, 0761 is the design published as the Collapsible Tray with Hinged Lid. The four-digit code carries the full structural intent — specify it to any converter and both sides mean the same construction; only dimensions and board grade remain to be agreed.

How the structure behaves

A collapsible tray with a hinged lid: the construction is glued during manufacture, ships collapsed flat, and springs into an erected tray in one movement, with the lid hinged to close over it. Codes 0759 and 0761 share this published name and differ in construction detail — the 3D fold shows how this one erects.

Typical uses

Pre-glued trays pay off where erection speed matters: high-volume food service, retail counters and packing stations where each unit must be ready in a second, with no loose lid to manage.

Dimensions and board

The parameters above — internal length, width and depth, plus any construction-specific values this style needs — drive the whole blank: panel layout, flap depths and slot positions all derive from them, validated against the template's supported range. The 2D dieline and the 3D fold preview regenerate together from the same parametric structure.

A corrugated dieline is a starting point for production, not a substitute for converter judgment: flute profile, board grade and joint style all affect final dimensions and crush behavior. Confirm tolerances and material with your manufacturer before mass production — and erect the structure on screen first, so flap collisions and proportion problems surface before any tooling is ordered.

What is Collapsible Tray with Hinged Lid — Model 2?

FEFCO 0761 is the corrugated design published in the FEFCO International Fibreboard Case Code as the Collapsible Tray with Hinged Lid; the four-digit code specifies the full construction, leaving only dimensions and board grade to agree.

Which dimensions does the Collapsible Tray with Hinged Lid — Model 2 dieline need?

4 parameters drive the blank: L (length), W (width), D (depth), Corrugated cardboard thickness (mm). Each value is validated against the template's supported range, and the whole dieline regenerates from them.

Can I see how Collapsible Tray with Hinged Lid — Model 2 folds before cutting it?

Yes. The interactive 3D fold preview and the 2D dieline are generated from the same parametric structure, so the fold you watch on screen is the geometry of the sheet you cut. Open the template in the preview studio to fold it at your own dimensions.